SACC
/ / navigation
Parts
Instructions
/ / INTRODUCTION
Parts
felt or fabric
stuffing
conductive fabric
conductive thread
normal thread
2 leds
fusible interface (iron on)
/ / Instructions
Draw shape of doll on paper
Cut out template
Cut out your shape in fabric
Cut out another shape in fabric. One will be the front, the other the back.
Stick led leads through front head.Put both anode leads in the center.
Fold leads down.
Turn leads in spirals, but make sure a needle can fit through the center.
Place a conductive fabric heart on the inside of the front chest
Peel off paper and iron on
Use a piece of conductive fabric to connect the pieces of fabric at the top of the head
Using conductive thread, sew the heart to the two center leads of the leds (anodes)
Attach the battery holder on the back side. It should be in the same place as the heart if the doll was folded over.
Sew the ground lead of the battery holder to the top of the head and then to the other leads of the leds (cathodes)
Place a battery in the holder
Cover the circuit with felt or fabric
Turn the doll over so that you can see the eyes. Place a felt heart on the outside over where the fabric heart is in the inside
Sew and stuff
Stick a needle through the heart-you'll connect the anode leads of the leds to power of the battery through the needle.